Networking and Communication
The Plan:
The plan was to create the Bus and two nodes as provided by the example on the Academy page.
The Process:
I milled and stuffed all three boards. I flashed the boards using the files provided. I had to change the .c file from the default to the number of the Node I was programming. I made the Bus 0, then named the nodes 1 and 2.
The Final Product:
As seen below in the video, when I use the serial monitor in Arduino, I can type the number of the node and hit send. When I hit send the boards flash in order, then the board with the corresponding number flashes a second time.
Video: Here
This week we were asked to build a wired or wireless network of at least two nodes.
Networking and Communication
Monday, April 30, 2012
Node 2, Node 1, and Bus (0)
Networked
Arduino Serial Monitor
